|
|
|
|
|
Rather than messing about turning off the ends, Bob cuts them off on the bandsaw |
He then installs a cup drive into the chuck |
The tailstock live center has had the spike removed and the sharp edges eased |
Bob trues up the cup drive to insure that it runs true on the lathe |
|
|
|
|
|
The sphere is located between the cup drive and the live center for additional turning |
After rotating it between the centers a couple of times, the sphere is finished |
While it is finished turned, Bob has a different setup for sanding |
Bob sets up the lathe with a vacuum chuck |
|
|
|
|
|
It is not necessary to use a vacuum chuck but it makes sanding much easier |
The sphere is re-oriented several times to sand it completely |
Bob gives it it's final sanding ... |
and another Bocci ball has been created |
|
|
|
|
|
It's been a long evening and it's time to tear down and clean up |
The video is packed up and the tables are cleared as the group heads out |
A look at some of Bob's miniature bird houses |
A closer look at some of Bob's ornaments after Susan has done her decorating |
|
|
|
|
|
Some burl and an interesting piece for the icicle |
Another of Susan's paintings |
A closer look at another |
|
| Go to page 1 |
Go to page 2 |
Go to page 3 |
Go to page 4 |
| Go to page 5 |
|
|
|
| |
|
|
|
Photos by Kurt Hertzog |
|
|
|
